Need help?Do you have a question about the Trane TAM4A0A36S31SB and is the answer not in the manual?
General| Model | TAM4A0A36S31SB |
|---|---|
| Type | Air Handler |
| Voltage | 208/230V |
| Phase | 1 |
| Maximum Overcurrent Protection | 30 Amps |
| Motor Type | ECM |
| Cooling Capacity | 36, 000 BTU |
| Heating Capacity | 36, 000 BTU |
| SEER Rating | Up to 16 |
| Blower Motor | Variable Speed |
| Nominal CFM | 1200 CFM |
| Width | 21 in |
| Height | 47 in |
| Shipping Weight | 160 lb |
Details the responsibilities of the owner for equipment maintenance.
Outlines critical safety warnings, cautions, and notices for safe operation.
Details requirements and hazards associated with field wiring and grounding.
Covers procedures and safety for lifting and rigging the unit or its sections.
Provides essential safety warnings and testing procedures for lifting heavy equipment.
Details the procedure for joining multiple unit sections together using provided hardware and gaskets.
Provides step-by-step instructions and safety warnings for installing air filters.
Details anchor specifications and installation for seismic compliance.
Details proper drain pan trapping methods to prevent water damage and ensure drainage.
Warns about electrical hazards, capacitor discharge, and lockout/tagout procedures.
Stresses the importance of qualified personnel for field wiring and grounding to prevent hazards.
Details the step-by-step process for calibrating the operator display's touchscreen interface.
Lists essential checks to perform before operating the air handler for the first time.
Details checks related to the fan assembly, including rotation, alignment, and belt tension.
Guides on checking motor lubrication, windings, rust, and corrosion before operation.
Explains how to measure and interpret motor voltage imbalance for proper operation.
Details the importance of proper belt tension and how to adjust it using a tensiometer.
Warns about potential hazards during maintenance and troubleshooting procedures.
Provides a table of common symptoms, probable causes, and recommended corrective actions.
Details procedures for replacing throwaway, permanent, and cartridge/bag filters.
Outlines inspection and cleaning procedures for drain pans, including safety warnings.
General safety warnings for individuals performing installation and service.
Provides detailed steps for brazing refrigerant lines, including panel removal and heat protection.
Provides a step-by-step guide for initiating system start-up, including thermostat and power settings.
Lists essential checks to perform after installation to ensure proper system performance.
To Next Page