To Next PageTo Next Page
Need help?Do you have a question about the Trane TAM4A0A18S11ED and is the answer not in the manual?
General| Model | TAM4A0A18S11ED |
|---|---|
| Type | Air Handler |
| Series | TAM4 |
| Cooling Capacity | 1.5 Ton |
| Blower Motor Type | PSC |
| Refrigerant | R-410A |
| Voltage | 208/230V |
| Width (in) | 17.5 |
| Depth (in) | 21 |
| Phase | 1 |
| Filter Size | 16 x 20 x 1 |
| Drain Connection | 3/4 in |
Details allowed locations for drilling and screwing into the unit cabinet.
Instructions for removing the four access panels of the unit.
Steps to check for damage, handle unit during transport, and prepare for installation.
Steps to disassemble the unit cabinet for installation in confined spaces.
Approved methods for lifting and carrying the unit to its installation location.
Table of model numbers with corresponding dimensions and net weight.
Instructions for orienting the unit for upflow, downflow, or horizontal configurations.
Guidelines for installing the unit without a return air duct.
Guidelines for installing the unit with a ducted supply and return air.
Further considerations for installation, including noise, clearances, and approvals.
General considerations for vertical installation, including height and foundation.
Steps and notes for performing an upflow installation.
Steps and important notes for performing a downflow installation.
Key considerations for installing the unit in a horizontal position.
Important factors for connecting supply and return air ducts to the unit.
Table detailing vapor and liquid line connection sizes for various models.
Diagram illustrating the layout of refrigerant components like sensors and valves.
Step-by-step instructions for brazing refrigerant lines to the indoor coil.
Considerations for routing, sloping, and connecting condensate drain lines.
Procedure for connecting condensate drain piping for different orientations.
Table defining maximum total length of low voltage wiring based on wire size.
Instructions for drilling holes and routing low voltage wiring into the unit.
Matching high voltage power supply to the equipment nameplate and codes.
Steps for routing high voltage wiring and connecting conduit to the unit.
Procedure for securing the coil panel bracket and seal plate to the unit.
Information on filter installation, maintenance, and sizing for different cabinet sizes.
Steps to ensure the system is properly started after installation.
Detailed sequence for continuous fan operation.
Sequence of operation for heatpump cooling mode.
Sequence of operation for heatpump heating mode.
Sequence of operation for standard cooling mode.
Sequence of operation for electric heating mode.
Information about the optional condensate switch and its operation.
How the EVC control prevents the coil from icing and initiates defrost.
A comprehensive checklist for verifying system performance after installation.
