30
18-GJ89D1-1D-EN
Electrical — Low Voltage
Table 14. Low Voltage Hook-up Instructions
Note: Strain relief must be provided on the inside of the air handler
cabinet for the low voltage wiring. Field supplied thermostat
wired may be wire tied as a bundle to the existing strain
relieved low voltage pigtail leads in the air handler unit.
1. Route control wiring to unit. Remove the external sheathing of
the wiring approximately 5”.
Note: Optional Low Voltage Conduit Entry Kit number BAYLVKIT100A
is available.
2. Remove Coil panel by turning the Phillips head door fasteners,
rotating the door away from the cabinet.
To Next Page
Loading...
