20
Installation - Vehicle Powered Compressor
Installation
NOTE: Always confirm compressor installation kit is correct for your
vehicle
before preceding with the installation.
Add only 4 oz. of oil (supplied) to the road compressor and rotate clutch
end to circulate the oil throughout the compressor.
• Do not add more than 4 oz. of oil to the compressor at this time.
• Additional oil will need to be added later to the system.
See “TOTAL AMOUNT OF OIL REQUIRED” on page 43.
Install compressor on the vehicle by following the instructions included in
the compressor kit.
Compressor Ground Wire
Install the chassis ground wire to the compressor frame using the supplied
hardware. Ensure the mounting location on the chassis is free of any paint.
Use anti-corrosion gel (203-377) or equivalent on ground wire connection
to compressor and vehicle chassis.
IMPORTANT: Failure to install the compressor ground wire to the
chassis may result in intermittent clutch operation and premature clutch
failure!
To Next Page
Loading...
