14
TK 56321-18-IM-EN
Condenser Installation
IImmppoorrttaanntt:: See Section 4 - Unit Installation Standards and Procedures in the Thermo King Vehicle Powered Truck
Installation Standards and Procedures Guide (TK 56430). THESE PROCEDURES MUST BE FOLLOWED!
MMOODDEELLSS 2200 aanndd 5500 OONNLLYY - After installing condenser, reinstall power tray and reconnect electrical wires removed
earlier.
NNoottee:: Nose mount and roof top condenser mounting and access hole dimensions can be found at the back of this
manual.
WWAARRNNIINNGG
EEqquuiippmmeenntt DDaammaaggee!!
SSeeaall aallll tthhee hhoolleess iinnssiiddee tthhee eelleeccttrriicc bbooxx wwhhiicchh aarree nnoott uusseedd ffoorr iinnssttaallllaattiioonn ((ddeeppeennddiinngg nnoossee mmoouunntt//rrooooff ttoopp))..
OOtthheerrwwiissee wwaatteerr wwiillll ggeett iinnttoo tthhee eelleeccttrriicc bbooxx aanndd ddaammaaggee tthhee ccoommppoonneennttss..
Figure 1. Condenser Mounting Bolts
1. Mounting holes when unit is mounted on the Front of the Truck (6)
2.
Mounting holes when unit is mounted on the Roof of the Truck (6)
To Next Page
Loading...
