22
F/C Settings
The F/C Settings screen is use to select the temperature display mode.
Fahrenheit (F) or Celsius (C) are the two available modes.
Change the Temperature Mode
1. Press the MENU button.
2. Scroll to UserÎSettings and press the Select button.
3. Scroll to F/CÎSettings and press the Select button.
4. Press the plus (+) or minus (-) buttons to change the temperature mode.
Select F for Fahrenheit or C for Celsius.
Internal Sensor Calibration
The Sensor Calibration screen is used to change the temperature calibration
of the internal temperature sensor. The temperature calibration can be
changed by +/- 7 degrees.
When the Sensor Calibration screen is selected, the current temperature
calibration is displayed. In the example screen, the calibrated temperature is
77 and the number of degrees of offset being applied is 1.
Change the Sensor Calibration
1. Press the MENU button.
2. Scroll to UserÎSettings and press the Select button.
3. Scroll to SensorÎCalibration and press the Select button.
4. Press the plus (+) or minus (-) buttons to change the sensor calibration.
ÎÎ After this screen is closed, it may take a few seconds for
the temperature displayed on the main thermostat screen to
update to the new temperature.
Usage Graph
The Usage Graph shows daily heating and cooling runtime hours for a week.
The button in the lower right corner will change depending on what is being
displayed. When the heating time is displayed, the button will read Cool.
When the cooling time is displayed, the button will read Heat Press the
Heat/Cool button to display the heating/cooling time.
F/C Settings
F/C Mode F
Done
+ -
Sensor Calibration
Internal (77) 1
Done
+ -
Heating time (Hrs)
Done Cool
20
15
10
5
Sun Mon Tue Wed Thu Fri Sat
To Next Page
Loading...
