Need help?Do you have a question about the Trane WPHF and is the answer not in the manual?
Inspect unit upon arrival for shipping damage, verify nameplate data, power supply, and refrigerant charge.
Guidelines for indoor and outdoor storage to prevent damage and microbial growth.
Location and details found on the unit nameplate, including model, serial, and electrical data.
Location of compressor identification data on the compressor shell.
Unit is leak tested, dehydrated, charged, and run tested before shipment.
Details on the construction materials and leak testing of the heat exchanger.
Information on water connection sizes and labeling for supply/return.
Location of the blower/motor and its serviceability through the access panel.
Overview of available control systems (Basic 24V, Tracer ZN510).
Details on the LonTalkTM certified control board and its supported options.
Location of low and high side refrigeration system connections on the front panel.
Recommendations for unit placement and required service clearances.
Summary of steps for successful unit installation, including inspection and initial checks.
Requirements for main power wiring, including disconnect switch and grounding.
Guidelines for low voltage wiring, including conductor types and routing.
Instructions on filter installation and the importance of not operating without them.
Step-by-step procedure for starting up the unit and verifying its operation.
Suggestions for routine maintenance, including filter checks and cleaning.
Details of the standard parts-only warranty period.
Information on optional extended warranty coverage periods.
Notes on standard unit design and performance in unconditioned spaces.
How the unit operates with safety controls and thermostats.
Initial checks to perform before consulting the troubleshooting chart.
To Next Page
General
