Need help?Do you have a question about the Transcell Technology TI-500 RF Series and is the answer not in the manual?
General| Display Type | TFT |
|---|---|
| Touch Points | 1 |
| Communication | RS-232 |
| Operating Voltage | 12V DC |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 60°C |
Out of the box, the TI-500 RF series indicator operates as a basic, cabled digital weight indicator.
Press and hold the ON/PRINT key on the digital indicator unit for two seconds. After a brief initialization period, the scale will revert to a zero display.
Switch on the RF weighing module(s) by pressing the BLUE button once. Then press and hold the ON/PRINT key.
Before weighing, check if the scale is unloaded and indicating zero weight in the desired unit of measure.
The TI-500 RFTM contains two buttons and one LED. The BLUE button powers up the RF module.
This key toggles the indicator between lb and kg.
This key sets the indicator to display zero weight provided the following conditions are met.
This key toggles the indicator between Gross weight and Net weight - but only if a Tare weight has been established first.
This key is used to establish a Tare weight provided the following conditions are met.
Press and hold for two seconds to turn the unit ON. When the unit is on, this key is used to send weight information out to the serial port.
This mode of operation is enabled by setting F30 to “5” in the Setup Menu. This mode captures the weight of an unstable load.
Gross weight refers to the total weight of a product and its packaging. Conversely, net weight refers to the weight of the product alone.
Aluminum/ABS enclosure, 0.8", 6 digit LCD w/LED backlight, Operating temperature 14°F to 104°F.
Stainless steel enclosure, 0.8", 6 digit LCD w/LED backlight, Operating temperature 14°F to 104°F.
2.0, Class I, Up to 100m unobstructed, (ISM) band at 2.4 to 2.485 GHz.
4 AA alkaline, User replaceable, 85+ continuous hours of operation.
6 volt 3 Ah internal rechargeable lead acid battery, 115+ continuous hours of operation.
Holds 1.5 volt x 4 "C" alkaline, User replaceable, 130+ continuous hours of operation.
'Low Battery' icon blinks on the digital readout, then the indicator powers off. Replace or recharge the batteries.
Check for any type of mechanical binding or impingement of scale that is displaying the lower weight.
Scale is overloaded. Remove weight from scale. Check cable, load cells, or internal fault.
The indicator has a power conservation feature, set to automatically power off the scale after 30 minutes of non-use.
A battery may be fully depleted. If so, this condition can cause erratic displays. Power off the indicator and replace or recharge the battery.
To Next Page
