Transcend DrivePro 50 - Recording Videos; Emergency Recording

8
1. Connect the small end of the car adapter to the USB connector of the DrivePro™.
2. Plug the other end of the car adapter in your car’s lighter socket.
3. After the car engine is switched on, the DrivePro™ will automatically turn on and start
recording.
Note: To use for the first time, please set the date, time and time zone using the DrivePro™
New App.
5. Recording Videos
After the car engine is switched on, the DrivePro™ will automatically power on with Wi-Fi and start
recording. The LED indicator will flash blue. By default, one video file is saved for every 3 minute of
recording. To adjust the recording length, please refer to 6-5 Settings section in this manual.
After the car engine is switched off, the DrivePro™ will automatically save the current recording and
power off.
Note:
1. Lighter sockets of some types of vehicles will still supply power after the car engine is turned off. If
your car is of this type, please unplug your car video recorder from the lighter socket to avoid
unnecessary power consumption and unexpected issues.
2. If you want to record by the built-in battery, please make sure that it has sufficient power supply.
3. It takes at least 4.5 hours to charge the battery from low to full by an AC/DC adapter (Output:
DC5V1A).
5-1 Emergency Recording
30% of the storage space will be saved for emergency video files. Video files recorded in emergency
mode are protected from being overwritten.
1. G-Sensor Event Recording:
During video recording, the DrivePro™ will automatically activate Emergency Recording mode
when detecting a collision.
 If the G-Sensor sensitivity is set to “High”, even minor shocks will activate Emergency
Recording mode.
 If the G-Sensor sensitivity is set to “Low”, only significant shocks will activate Emergency
Recording mode.
G-Sensor sensitivity can be adjusted or disabled using the DrivePro™ New App. Please refer to 6-5
Settings section in this manual.
2. Manual Event Recording:
During video recording, quickly press the emergency button on the left side of the DrivePro™
to manually activate emergency recording mode. You will hear a beep and the LED indicator
will flash blue quicker than before.