Transcend DrivePro 50 - Transferring Files to a Computer

17
Available options: Disable / Enable
Delay Power Off: Schedule the DrivePro™ to shut down at a certain time.
Available options: Disable / 10 secs / 30 secs
Date: Set the date format.
Available options: YY/MM/DD or MM/DD/YY or DD/MM/YY
24-Hour Time: Select the 24-hour or 12-hour time format.
Available options: Enable (24-hour) / Disable (12-Hour)
SSID: Enter the SSID to wirelessly connect to DrivePro™ 50 (default SSID is
DrivePro™50).
Note: If you change the SSID, it will be renewed when you reconnect to Wi-Fi.
Password: Enter the password to connect wirelessly to DrivePro™ 50 (default password
is 12345678).
Note: If you change the password, it will be renewed when you reconnect to Wi-Fi.
Format SD Card: Tap to format your SD card.
Firmware Upgrade: Tap to upgrade the firmware to the latest version.
WARNING: NEVER remove the power cable or the microSD memory card while
the firmware is being upgraded.
1. The DrivePro™ will shut down and the red LED light will flash while the firmware is
being upgraded. After the upgrade is complete, the DrivePro™ will restart
automatically.
2. If the DrivePro™ cannot be turned on due to firmware upgrade failure, please
contact Transcend customer service for technical support.
7. Transferring Files to a Computer
To transfer files between the DrivePro™’s memory card and your computer:
Option 1: Take the microSD memory card out of the DrivePro™, and insert to a compatible card
reader to transfer files to your computer.
Option 2:
1. Insert the microSD memory card into the DrivePro™.
2. Plug the small end of a USB cable into the Mini-B USB port located on the left-hand side of
the DrivePro™.