Menu Options
Resolution: Set the resolution/quality for video recording (front lens+rear lens).
Available options: 1080P+720P (default) / 720P+720P
Exposure Value: Adjust exposure composition value to lighten or darken the preview
screen.
Available options: +0.5 +1.0 +1.5 +2.0 / 0 / -0.5 / -1.0 / -1.5 / -2.0
Video Length: Set the recording length of each recorded video file.
Available options: 1 min / 3 mins (default) / 5 mins
Display: Display both lenses or the front / rear lens only.
Available options: Front / Rear / Both (default)
Head-Up Display: Display the current speed and safety alerts onscreen.
Available options: Disable (default) / Enable
Video Stamp: Display the current time of the event or GPS information of the video being
recorded.
Available options: Disable / Enable
Loop Recording: Overwrite the earliest video files with new ones if the microSD card
capacity is full.
Available options: Disable / Enable (default)
Microphone: Turn on/off the microphone during video recording.
Available options: Disable / Enable
Volume: Set the speaker volume level.
Available options 0 / 1 / 2 / 3 / 4 / 5 / 6 / 7 (Choose 0 to switch on Silent Mode)
Light Frequency: Select the appropriate frequency to avoid flashing A/C light.
Available options: 50Hz / 60Hz
Time-Lapse Video: Set a preferred time interval to make time-lapse videos. Time-lapse
video mode can only be enabled manually; once enabled, it will replace Normal recording mode.
Available options: Disable (default) / 1 shot per sec / 2 sec per shot / 4 sec per shot
Note: To prevent the car battery from being completely drained, the DrivePro will automatically
power off after 48 consecutive hours of recording in Time-Lapse Video mode.
To Next Page
Loading...
