-14-
(4) Heater temperature
Set the knob to position 3 or 4. Adjust the heater temperature by selecting a position
between l and 6. Choose the suitable temperature, bearing in mind the environmental
conditions of the machine. If the heater temperature is too high or too low, a proper seal
will not be obtained.
Gradually increase or reduce the position until obtaining an optimum seal.
8. Maintenance & Lubrication
Warning:
Before any maintenance or repairs on the machine, set the Power Switch to
"O" (OFF). Wait about 5 minutes for cooling down the heater to avoid burns
with this area.
(1) Cleaning and Lubrication
The high reliability and long service life of the strapping machine will depend on regular
cleaning and maintenance.
ATTENTION!
All the important strap transport components, such as the tension rollers and the
strap guides, must be kept free from oil and grease. (lubricant)
The lubricant has to be non-resinous.
The lubricant is SAE 30
To Next Page
Loading...
