Need help?Do you have a question about the Transtecno CMG 022 and is the answer not in the manual?
Highlights risks associated with rotating parts and the importance of safety during operations.
Warns about potential severe damage or death resulting from incorrect usage or non-compliance.
Instructions to verify product nameplate details before installation, emphasizing warranty implications.
Key checks before installation, including product matching, surface preparation, shaft alignment, and safety guards.
Procedure for mounting motors without couplings, focusing on tolerances, cleaning, and alignment.
Procedure for mounting motors with couplings for specific gearboxes, focusing on tolerances and connection.
Guides for fitting devices onto solid shafts, using lubricants, tools, and balancing high-speed shafts.
Guides for fitting devices onto hollow shafts, using lubricants, tools, and adhering to load limits.
Procedures for mounting torque arms on ATS and ITS gearmotors, detailing components and distances.
Pre-service checks for oil level, leaks, mounting conformity, and motor voltage, plus ATEX considerations.
Guidelines for gradual start-up, avoiding immediate full load, and initial running-in for worm gearmotors.
Common operational problems (no start, high temp, noise, vibration) with causes and suggested solutions.
Details periodic inspection tasks and intervals (3000h/6m, 10000h) for various components.
Pre-installation checks for ATEX units, ensuring no damage, residue, or corrosion, and proper documentation.
Post-start-up checks for ATEX units, monitoring surface temperature and ambient conditions.
Maintenance guidelines for ATEX gearmotors, including surface cleaning, repainting, re-greasing, and oil leak checks.
Lists prohibited uses and restrictions for ATEX gearmotors, including environmental limits and classified areas.
General| Brand | Transtecno |
|---|---|
| Model | CMG 022 |
| Category | Engine |
| Language | English |
To Next Page
