During the data transmission, If no cellular coverage or
cellular connection error occurs, The symbol will
appear on the LCD. Refer to page 22 for more information.
During the data transmission, If the data transmission
error or server connection error occurs, The symbol
will appear on the LCD. Refer to page 22 for more
information.
2. After the measurement, the data transmission
starts. The symbol will appear on the LCD.
Adjust the zero point
Inflating and measuring
Display the measured result
When the “TRIPLE MODE” button is located on “OFF”, the monitor is under the Single
Measurement mode.
When the monitor is OFF, press the “START/STOP” button to turn on, and then it will
complete the whole measurement automatically.
LCD display
Start a measurement
MEASUREMENT MEASUREMENT
A: Using Single Measurement Mode
If successful, the symbol will disappear and
the LCD will display “ ”.
seconds.
otherwise it will power off automatically within several
Press the ”START/STOP” button to turn off the device,
145
13
To Next Page
Loading...
Need help?
General
