12
TranzX PST calibration
Calibration 1 (CAL1): Turn on the system and make sure
the wheels are lined up in a straight line on the ground.
Press the background light button for approx. 6 seconds
until the display shows “CALXX.X”. This procedure
calibrates the TranzX PST-System.
After this, you can start riding your bicycle.
Note: Make sure to exercise this procedure after
adjusting or removing the rear wheel, after replacing the
display and after transporting the bicycle.
Final Check
After completion of the assembly, please make sure that:
1. Every screw is tightened properly,
2. tires are inflated to the recommended pressure,
3. brakes are working properly,
4. and that the system is calibrated.
Battery case operation:
1. Turn the key anti-clockwise and open the plastic casing. (Images 20&21)
2. Take out the battery for charging.
(Image 22).
Img. 16
Img. 15
Img. 14
Img. 19
To Next Page
Loading...