TranzX ES 504 - How to Charge the Battery; Charger Usage and Safety; Charger LED Indication and Time; Charger and Battery Protection Features

13
How to charge the battery
Only use the charger that was supplied by TranzX PST. The use of any other charger voids your warranty,
may result in severe damage to the battery and electrical system of the bicycle, and in the worst case may
cause a fire hazard.
• Make sure the voltage specification of the changer meets your local voltage.
• Connect the battery with the charger.
• Fully charge the battery until the light turns green before riding the bicycle for the first time.
Charger LED Indication
• The red light indicates the battery is charging (Image 23).
• The green light indicates the battery is fully charged (Image 24).
Charging time
The Li-ion battery will take approximately 6 hours to fully charge.
Charger & battery protection
• The battery and charger have a built-in heat sensor. In case the heat rises too high, it will automatically
shut down the system before any damage can occur.
• The charger will automatically cut off the power supply after 6 hours of charging.
Img. 23
Img. 24