trapKAT 4 - COPY KITS; SOUND CONTROL (Volume, Bank, Program Change)

screen. This screen allows yow to set a specified time in which your HiHAT notes will overlap instead
of abruptly cutting each other off. This will create a more realistic sound. The Overlap times are the
same as the Gate Time Settings (.005-6.3, Roll Mode, Infinite)
COPY KITS
Pad # 15 and 16
It is possible to copy a preset Factory Kit or a User Kit to any of the 24 User Kit locations. “Kit Copy”
will always copy the KIT you are currently in to some other selected USER Kit. Kit Copy is performed
using pads # 15 and #16, when the Kit Edit footswitch is depressed.
When pad #15 is struck, the screen will display “Copy Current Kit to User Kit XX”. While the
footswitch is still held down, hit pad #15 repeatedly. You will see the User Kit value increment with
each hit of the pad. When you reach the User Kit location where you want to store this current kit, Hit
pad #16. The screen will ask you to verify that you want to do this. Hit pad #16 again to Store the Kit.
So remember, pad #15 Changes the Kit Number and Pad 16 performs the copy function
SOUND CONTROL (Volume, Bank, Program Change)
Pad # 19 and 20
The trapKAT KS can send out 4 different Bank Changes, Program Changes and Volume Changes on 4
different MIDI channels. With the KIT Edit footswitch held down, tap on pad #19 (left of the display).
This is a “tunnel” screen, meaning that each time you tap on pad #19, a new screen pops up. These are
the Screens in the Tunnel. Here are the screens in the Tunnel
Volume 1 = xxx
Program Change 1 =xxx
Program Change Channel 1 = xxx
Bank (MSB1) = xxx
BANK (LSB1) = xxx
Volume 2 = xxx
Program Change 2 =xxx
Program Change Channel 2 = xxx
Bank (MSB2) = xxx
BANK (LSB2) = xxx
Volume 3 = xxx
Program Change 3 =xxx
Program Change Channel 3 = xxx
Bank (MSB3) = xxx
BANK (LSB3) = xxx
28