held down, the display rotates through the screens. The default value is NO. This doesn't mean that
there is no effect or volume, it means that the trapKAT (the user) is not overriding the settings of the
volumes, reverb and EFX that was preset at the factory. The value range goes from 00-127
Filter Putting a value here other than NO adds a Filter effect to the entire kit.
Pitch Changes the pitch of the entire kit up or down
Kick Vol Raises or lowers the kick drum sounds
Snare Vol Raises or lowers the snare drum sounds
Tom Vol Raises or lowers the tom sounds
HiHAT Vol Raises or lowers the HiHAT sounds
Misc Vol Raises or lowers the rest of the sounds
FX affects the amount of the effects channel (usually chorus or delay)
Reverb affects the amount of reverb
KIT NAMING
Pad #21
It is possible to assign a name to your User Kits, using up to 12 letters. Hit pad #21 twice while holding
down the Kit Edit footswitch.
To change the character of the letter that's flashing, use the following pads
Pad 1 assigns upper case letters
Pad 11 assigns lower case letters
Pad 2 assigns a Space between characters
Pad 12 assigns a character
Pad 3 advances the cursor
Pad 13 reverses the cursor
Pad 4 advances the characters
Pad 14 reverses the characters
New to the trapKAT 5KS (with the Kurzweil Sound Engine) is the auto loading of kits and their names
when using the “special note numbers” called Program Advance and Program Backwards. When pads
are tapped with their notes assigned to these “numbers”, a new drum kit and their name is automatically
loaded into the kit. This is the fastest way to Kit Name. If you want to use this kit permanently, all you
have to do is Save the Kit in the Global Screen pad # 21
ALL NOTES OFF
Pad # 22
If a note ever get's stuck on (does not shut off), the trapKAT can send a ALL NOTES OFF command
that will shut off all notes. Simply Step on the Kit Edit Footswitch and hit pad #22 twice.
30
To Next Page
Loading...