Need help?Do you have a question about the Traxxas SLASH 4x4 VXL and is the answer not in the manual?
General| Scale | 1/10 |
|---|---|
| Drive System | 4WD |
| ESC | VXL-3s |
| Shock Length | Long |
| Transmission | Single-Speed |
| Steering | Bellcrank |
| Radio System | TQi 2.4GHz |
| Suspension | Independent |
| Charger | Not included |
| Waterproof | Yes |
| Motor | Velineon® 3500 Brushless |
| Top Speed | 60+ mph with 3S LiPo |
| Length | 568 mm (22.36 inches) |
| Width | 12.0 inches (305 mm) |
| Height | 193 mm (7.6 inches) |
| Wheelbase | 324 mm (12.75 inches) |
| Front Track | 296 mm (11.65 inches) |
| Rear Track | 296 mm (11.65 inches) |
| Center Ground Clearance | 72 mm (2.83 inches) |
| Tire Diameter | 4.3 inches (110 mm) |
| Tire Width | 43 mm (1.7 inches) |
| Wheel Diameter | 56 mm (2.2 inches) |
| Gear Pitch | 32 |
| Differential Type | Sealed, Hardened Steel Bevel |
| Chassis Type | Molded Tub |
| Chassis | Composite |
| Battery Type | NiMH or LiPo |
Key safety advice for responsible model operation and avoiding injury.
Precautions to prevent damage to the ESC and associated components.
Critical safety warnings and risks associated with LiPo battery use.
Essential guidelines for safe charging of all battery types.
Procedures for safe battery charging environments and unattended operation.
A procedural checklist to get the model running quickly.
Critical advice to maintain radio range and prevent antenna damage.
Lists compatible and recommended battery packs for the model.
Essential rules for proper transmitter and receiver usage.
Explanation of the built-in failsafe for signal loss protection.
Steps to verify radio system range before operating the model.
Configuring LVD for LiPo or NiMH batteries to prevent over-discharge.
Step-by-step guide to programming the VXL-3s ESC.
Selecting between Sport, Race, and Training driving modes.
Interpreting LED indicators for status and protection modes.
Key safety and operational guidelines for driving the model.
Guidelines for driving the model in wet environments.
Checks and preparations before running the model in wet environments.
Procedures for cleaning and maintaining the model after wet operation.
Procedure for setting gear mesh to prevent stripped gears.
Critical information and warnings for LiPo battery users.
To Next Page