Covers Part #9095
LED Light Kit Installation Instructions
Kit contents:
• 3-volt accessory power supply
• Electronic speed control (ESC) power tap
• Front bumper with LED light bar
• Rear bumper with LED light bar
• 3x8mm button-head cap screws (2)
• 2.6x8mm button-head cap screws (2)
• Zip ties (3)
TRAXXAS.com
Traxxas, 6250 Traxxas Way, McKinney, TX 75070,
Phone: 972-549-3000, Fax: 972-549-3011, e-mail: support@Traxxas.com
HKC20071-R00 Rev 201023
Tools needed:
• 2.0mm hex wrench
• 2.5 mm hex wrench
Visitez Traxxas.com/manuals pour télécharger
les instructions dans votre langue.
Visite la página Traxxas.com/manuals para
descargar el instrucciones en su idioma.
Auf Traxxas.com/manuals, können Sie
anleitung in Ihrer Sprache downloaden.
A
4x18mm BCS
3x15mm BCS
B
1
4x14mm BCS
Remove the existing front and rear bumpers (A, B).
Retain and reuse all screws.
4
2.6x8mm BCS
(self-tapping)
Install the cover on the power tap.
ESC Power
Tap Cover
ESC Wiring
3x8mm BCS
C
D
E
2
4x18mm BCS
3x15mm BCS
4x14mm BCS
E
Install the new front and rear bumpers (C, D) using the screws
removed in step 1; then, install the accessory power supply (E)
with the included 3x8mm BCS (2).
CAUTION: RISK OF DAMAGE TO
BATTERIES!
Do not attach the power tap to the battery
connector. Attach to the electronic speed control (ESC) connector only.
Always disconnect the battery from the ESC when not in use to prevent
the possiblity of over-discharge.
CAUTION: RISK
OF DAMAGE TO
ACCESSORIES!
Note the polarity and wire color on
the pre-installed wires on the power
tap. Ensure the polarity is correct
during installation on the High-
Current Connector: red (+) (positive),
black (-) (negative).
Important Note! Use the included power tap as the direct battery source for the accessory power supply.
Do not connect to the accessory BEC power output on the ESC (if equipped). Connecting high-load
accessories to the power supply while it is plugged directly into the ESC could overload the speed
control’s BEC circuit. This may cause the speed control to go into thermal protection mode or could cause
damage to the speed control.
3
High-Current
Connector
Attach the power tap to the High-Current Connector of the electronic speed control (ESC).
ESC
Power Tap
ESC Wiring
During installation, be sure that
the terminals of the High-Current
Connector and the power tap
make full contact.
ESC Wiring
Power Tap
Wire colors
mismatched
To Next Page
Need help?
General
Weight and Dimensions
