Need help?Do you have a question about the Traxxas Slayer pro 4x4 and is the answer not in the manual?
General| Scale | 1/10 |
|---|---|
| Drive System | 4WD |
| Engine | TRX 3.3 Racing Engine |
| Fuel Type | Nitro |
| Chassis | 3mm 6061-T6 Aluminum |
| Fuel Tank Capacity | 150cc |
| Top Speed | 50+ mph |
| Radio System | Traxxas TQi 2.4GHz |
| Servos | High-Torque Waterproof |
| Transmission | 2-speed automatic |
A guide to get your model up and running quickly with essential procedures.
Key safety warnings and essential advice for safe operation of the model.
Guidelines for safe handling, charging, and storage of batteries for the model.
Essential rules for safe and proper operation of the radio system.
Instructions for verifying radio range to ensure proper operation.
Overview of the TRX 3.3 Racing Engine and its advanced features.
Importance and initial steps for breaking in the engine for optimal performance.
Crucial steps for cleaning and maintaining the air filter for engine longevity.
Essential procedures for after-run maintenance to prevent engine corrosion.
Guidance on selecting and using the correct fuel for optimal engine performance.
Important safety and handling guidelines for model engine fuel.
Steps for cleaning the pre-filter element after every hour of running.
Steps for cleaning the primary filter element after 3-4 hours of running.
Explanation of the carburetor's functions and air/fuel mixture process.
Details on the high-speed and low-speed mixture needles for tuning.
Procedure for adjusting the engine's idle speed using the idle speed screw.
Overview of the EZ-Start electric engine starting system.
Instructions for charging the 7.2-volt battery pack for the EZ-Start.
Detailed step-by-step procedure for proper engine break-in.
Instructions for the initial startup of the engine.
Break-in procedure for the first tank of fuel, focusing on gentle acceleration.
Break-in procedure for the second tank of fuel, with increased acceleration.
Break-in procedure for the third tank of fuel, including idle speed adjustments.
Break-in procedure for the fourth tank of fuel, with full throttle acceleration.
Break-in procedure for the fifth tank of fuel, including second gear shifting.
General guidelines for tuning the engine's fuel mixture for optimal performance.
Detailed steps for adjusting the high-speed needle for performance tuning.
Detailed steps for adjusting the low-speed needle using the pinch test.
Important precautions and advice before operating the Slayer Pro 4X4.
Advice for operating the Slayer Pro 4X4 safely and effectively.
Tuning the slipper clutch for drivetrain protection and optimal performance.
Steps for after-run maintenance to protect the engine from internal corrosion.
Procedure to clear an engine that has become flooded with fuel.
Steps to release a piston stuck at top dead center.
Adjusting differential fluid viscosity for varying traction conditions.
To Next Page