Treadly 2 - Automatic Control Mode; Automatic Mode Overview; Starting Automatic Mode

&
Automatic Control Mode
Automatic control mode uses the AUTO RUN 2.0 intelligent speed control system that controls
Treadly’s running mode without buttons.
When you first use Automatic Control Mode, you must have the handrail completely unfolded
and upright. If you encounter an emergency during operation, press the Stop button or the
Emergency Stop Switch, and the Treadly will come to a halt.!
You can use this mode completely without the handrail buttons or remote control and we
recommend it for more experienced users.!
Orthotic insoles or high heels are not suitable for this mode. Automatic control mode requires
learning and adaptation.!
Start
Start at the back of the Treadly belt, and walk three steps at a normal walking pace.
Maintain 2 - 4 inches of space between each foot (see picture below).
The display shows the content as it is synchronized with the steps (see picture below).
After completing three steps, the Treadly will be in automatic mode, and will record
your movement data.!
Walking
| 18