Treadly TR100 treadmill contact@treadly.co page 12
To apply the silicone lubricant, do the following:
1. Place the treadmill on an even and non-slippery surface.
2. Lay the treadmill down so its left side is facing up.
3. Lift the running surface up starting from the upper corner, as
shown in the picture above.
4. Apply the silicone lubricant by squeezing droplets underneath
the running surface, ensuring the lubricant is applied at least 4-6
inches (10-15 cm) towards the middle of the running surface.
5. Lift the treadmill back up, and lay it down so the right side is
facing up.
6. Lift the running surface, and apply the silicone lubricant
underneath the running surface, as you did in steps 3 and 4.
7. Return the treadmill to its operating position.
8. Plug the treadmill into a 110v outlet.
9. Start the treadmill with 3 steps in each area mode and keep the
treadmill at a steady pace for at least 2 minutes.
To Next Page
Loading...
