Treadly TR100 treadmill contact@treadly.co page 10
When the treadmill is in Stop mode for more than 5 seconds, it will go
into Standby mode to save power. To reactivate the treadmill, tap your
foot in the Decelerate area 3 times within 5 seconds.
Note: If the treadmill is in Standby mode for more than 10 minutes, the
treadmill will completely shut down. To start the treadmill again make a
step in each area of the running surface to get the running surface
moving, like you did to start the treadmill after plugging it in.
If you are finished your workout, please unplug the treadmill from the
outlet.
Maintaining'your'treadmill'
Your Treadly treadmill requires some routine maintenance and cleaning
to keep it in optimal working order.
Adjusting'the'running'surface'of'your'treadmill '
The running surface of the treadmill is automatically centered when it is
manufactured at the factory. After 3-5 months of normal use, you may
notice the following common issues that indicate that the running
surface requires adjustment.
The'running'surface'seems'loose'
If you notice that the running surface seems loose, Treadly recommends
that you use a hex key (Allen key) to alternatively turn the regulating
bolts clockwise in a 90-degree angle. Repeat until slipping of the running
surface is minimized.
To Next Page
Loading...
