Treadly TR100 - Page 14

Treadly TR100 treadmill contact@treadly.co page 14
Problem(
Possible(causes(
Solution(
Treadmill is not
working.
There is no electricity going to
the treadmill from the outlet,
or the treadmill is not properly
connected to a 110 volt outlet
Make sure that the
treadmill is properly
connected to a working
110 volt outlet.
The treadmill display
shows an E2 error
message.
The treadmill is overheated
and there is a large buildup of
friction.
Stop using the treadmill
for 30 to 60 minutes, to
let it cool down.
Lubricate the running
surface. For more
information, see
Lubricating your
treadmill.
The treadmill display
shows an E5 error
message.
The treadmill running surface
has significantly shifted to the
left or the right.
Adjust the running
surface. For more
information, see
Adjusting the running
surface of your
treadmill.
Treadmill
unexpectedly stops.
The treadmill was used
continuously for more than
100 minutes.
The treadmill
automatically stops
after 100 minutes of
continual use. Resume
work out in 30 minutes.
Noises are heard
from the treadmill
during your workout.
Certain noises are generated
by the treadmill engine and its
cooling system.
Treadmill is functioning
normally.
Treadmill has
shutdown
unexpectedly after
inactivity.
When the treadmill is in
Standby mode for more than
10 minutes, the treadmill will
completely shut down the
power.
Restart the treadmill by
stepping in each area of
the running surface to
get the running surface
moving.
'