SETTING UP YOUR SPEAKER
WIRELESS PAIRING
Turn ON
Press and hold the POWER button for 3 seconds. You will hear the
sound cue, the battery level indicators will light up and the BLUE
status indicator will start flashing.
• Turn on your speaker by pressing and holding the POWER
button for 3 seconds. You will hear the sound cue, the battery
level indicators will light up and the status indicator will start
flashing BLUE, meaning that the speaker is in pairing mode.
• Activate the wireless communication function on your device
(smartphone, tablet, laptop).
• Select TREBLAB HD-Max from the available devices list. Keep it
within 3 feet /1 meter of the speaker while pairing.
• If necessary, enter passcode 0000.
• Once HD-Max is successfully paired and connected, the LED will
stop flashing and stay BLUE.
Turn OFF
Press and hold the POWER button for 3 seconds. You will hear the
sound cue, and all the lights will go off.
Make sure TREBLAB HD-Max is charged and that the 3.5mm audio
cable or USB flash drive is not plugged in.
To Next Page
Loading...
