treesse FUSION SPA - Filling the Minipool; Drain and Suction Pumps

11
Fusion Spa minipool
EN
U
FILLING THE MINIPOOL
Filling is carried out by following the gures on the side
(follow the instructions for your keypad).
This occurs through a concealed spout in the compartment
on the bottom of the minipool and is indicated by the
illuminated red LED.
Filling takes place from the bottom of the bathtub, and
once it has nished the tank is lled.
After reaching the correct level, the system automatically
stops the lling and makes available the functions of
whirlpool, recirculation, ozone and heater.
During minipool use the system automatically maintains
the water level equal to the edge of the bathtub.
The minipool must ALWAYS remain connected to both the electrical grid and plumbing (lling and draining): this is
necessary for ltering, cleaning the lters and maintaining the minipool's water levels and temperature.
ALWAYS cover the minipool when inactive. This protects it from the sun's rays, prevents dirt from accumulating
inside the bathtub and keeps it from losing heat, thus optimising the efciency of the heater.
DRAIN AND SUCTION PUMPS
The minipool drain is positioned on the bottom, hidden
by the nishing plate.
This solution makes the use of the bathtub safer and
more comfortable.
To clean the drainage grate, just manually remove the
nishing plate since it is simply resting on the bottom.
For this operation see page 14.
Automatic lling using the keypad
simultaneously pressing the and keys activates the
automatic lling of the minipool, controlled by two level sensors and
conrmed by the "FILL" LED
Automatic lling using the keypad pressing the key activates the
automatic lling of the minipool, controlled by two level sensors and
conrmed by the xed blue key.