treesse FUSION SPA - Troubleshooting; Common Minipool Problems

37
Fusion Spa minipool
EN
D
PROBLEM POSSIBLE CAUSE SOLUTION
Cloudy water, not very clear or dust
in suspension
• Water with unbalanced values
(hardness, pH, alkalinity).
• Incorrect or infrequent water
treatment.
• Sand filter excessively dirty or
clogged.
• Excessive dirt brought in by users.
• Weather (if installed outdoors).
• Refer to the chapters:
1
page 22
2
page 26
3
page 30
• Take a shower before entering the
minipool to remove residues of
cosmetics or lotions.
• Cover the minipool when not in
use.
Sand inside the minipool
It is normal for there to be a minimum
amount of sand inside the minipool
during the rst hours of use of the
sand lter. After the rst cleaning of
the bottom the problem should no
longer exist.
Refer to the chapters:
3
page 30
Use of minipool cleaners.
Foam on the surface of the minipool
• Residues from sunscreens,
cosmetics, soaps.
• Water with unbalanced values
(hardness, pH, alkalinity).
• Overly soft water (lower hardness
to 7°f).
• Take a shower before entering the
minipool to remove residues of
cosmetics or lotions.
• Refer to the chapters:
1
page 22
2
page 26
Slippery bottom and walls, the pres-
ence of algae, greenish colour
• Water with unbalanced values
(hardness, pH, alkalinity).
• Incorrect or infrequent water
treatment
Refer to the chapters:
1
page 22
2
page 26
Bad odour or mould
• Water with unbalanced values
(hardness, pH, alkalinity).
• Incorrect or infrequent water
treatment.
• Water changed too infrequently.
• Canvas cover not cleaned well.
• Refer to the chapters:
1
page 22
2
page 26
• For the cleaning of the canvas
cover, see page 34
Below are some problems you may encounter while using the minipool.
If the solutions offered do not solve the problem contact your dealer or the minipool manufacturer for suggestions.
Troubleshooting