treesse minipool Quarz - Settings Filtration

73
EN
U
minipool Quarz
SETTINGS FILTRATION
Main ltration
The ltration cycles are set based on the duration. Start time is indicated by an “A” or “P” in the bottom right corner
of the display. Duration has no “A” or “P” indication. Each setting can be adjusted in 15-minute increments. The
panel calculates the end time and displays it automatically.
Sets Filter 1 length in hours
Sets start hour Shows/flashes minutes
Shows/flashes minutes
Sets 15-minute increments Shows/flashes start time
to display RUN HRS
to display F1 ENDS xx:xx
Sets 15-minute increments
Press Menu/Select
repeatedly until
FLTR 1 appears.
Main Screen
Main Screen
Sets Filter 1 length in hours
Sets start hour Shows/flashes minutes
Shows/flashes minutes
Sets 15-minute increments Shows/flashes start time
to display RUN HRS
to display F2 ENDS xx:xx
Sets 15-minute increments
Main Screen
To next
item in
Main Menu
Main Screen
Set
Set
Set
Set
Set
Wait a few seconds to
return to the
original setting
Wait a few seconds
to return to
the original setting
Wait to
Revert
*****
Wait a few seconds
to return to the
original setting
*****
Wait a few seconds to
cancel the Filtration 1
Start Time and Hours and
return to the previous
Filtration 1 settings.
*****
Set
Wait a few seconds to
cancel the ON/OFF,
Filtration 2 Start Time and Hours
and return to the previous
Filtration 2 settings.
*****
*****
Wait to
Revert
*****
*****
2X
2X
00
Key
+
-
Indicates a change in the display.
Indicates a continuous or intermittent message - every 1/2 second.
A temperature button, used for “Action”
Menu/Select button
Waiting time that keeps the last change to a menu item.
Wait time in which the initial settings are restored
by cancelling the changes made.
Filter cycle 2 - Optional ltering
Filter cycle 2 is OFF by default. It is possible to overlap Filter Cycle 1 and Filter Cycle 2, which will shorten overall
ltration by the overlap amount.
Purge Cycles
In order to maintain sanitary conditions, secondary Pumps will purge water from their respective plumbing by running
briey at the beginning of each lter cycle.
If Filter cycle 1 is set for 24 hours, enabling Filter cycle 2 will initiate a purge when Filter cycle 2 is programmed to
begin.
Use