treesse minipool Quarz - System Messages

81
EN
U
minipool Quarz
Use
SYSTEM
MESSAGES
DISPLAY SCREEN DESCRIPTION OF SIGNALS AND POSSIBLE SOLUTIONS
Memory fault -
Checksum error*
- M022
Problem description: at power-up, the system has failed the program
checksum test. This indicates a problem with the rmware (operation
program) and requires a service call.
Memory alarm
- Memory
cancellation* -
M021
Problem description: appears after any system setup change. Contact
your dealer or service organization if this message appears on more than
one power-up, or if it appears after the system has been running normally
for a period of time.
Memory fault
- Clock error
- M020 - Not
applicable on
BP1500
Contact Technical Service.
Conguration
error - The
minipool doesn’t
start
Contact Technical Service.
GFCI fault – The
system is not
connected to the
GFCI – M036
Problem description: ONLY IN NORTH AMERICA. It may indicate an
unsafe installation. Contact Technical Service.
Pump blocked in
ON mode - M034
Problem description: the water may have overheated. POWER DOWN
THE SPA. DO NOT ENTER THE WATER.
Contact Technical Service.
A pump appears
to have been ON
when the spa was
last powered -
MO35
Problem description: POWER DOWN THE SPA. DO NOT ENTER THE
WATER.
Contact Technical Service.
The water level is
too low
Problem description: some systems have a water level sensor, and this
message appears if it detects that the water level is too low.
* this message can be deleted from the top of the panel by pressing any key.