treesse Muse - Page 15

15
EN
U
Muse - Maya - Wave minipool
Use
BLOWER
(OPTIONAL)
OPTIONAL
OPTIONAL
The minipool can be equipped with:a single blower motor
activates the nozzles on the bottom or, alternatively, on
the seat to provide a soft and relaxing massage.
a second motor
activates the nozzles both on the seat and on the bottom.
If there is only one blower motor, pressing the key starts
the nozzle operation (default duration 20 minutes).
If there are two blower motors, pressing the key will
activate the function, alternating the two zones (bottom nozzles
+ seat nozzles) with an interval of 30 seconds and always for a
maximum duration of 20 minutes.
When the key is pressed again, the blower function stops,
the key returns to white and the temperature is shown again
on the display.
If the whirlpool key is pressed during the bottom blower
function, the whirlpool starts and stops the blower until it is
turned off.
If not switched off manually, the function stops automatically
after 20 minutes.
The function can be activated even without water.
For this reason it is useful to start it after emptying
the bathtub, to dry and drain the blower tubes.
CHROMATHERAPY
DI SERIE
Pressing the light key activates a sequence of 16 colours
that vary in an automatic sequence (default duration three
hours) (during the sequence the light key is ashing blue) .
Colour sequence: White, Red, Orange, Yellow 1, Yellow 2, Yellow
3, Green 1, Green 2, Green 3, Blue 1, Blue 2, Blue 3, Blue 1,
Blue 2, Blue 3, Purple.... White, Red, etc.
During this sequence, if you press the key again, the
current colour will remain xed (if a colour is xed, the light
key is xed blue) : To change it, simply press the key
several times until the desired colour is obtained (the colour
order is the same as the sequence).
Once you have selected a fixed colour, to return to the
automatic sequence you must turn off and reactivate the
function.
To stop the function hold the key for about two seconds.
The key will turn white again and the temperature will reappear
on the display.
If not switched off manually, the function stops automatically
after three hours.