treesse Muse - Page 16

16
EN
Muse - Maya - Wave minipool
Use
FILTERING
FUNCTION
FLT
EXAMPLE:
access to programming
tasto
nascosto
Setting the duration of
ltering (in the example d3=
3 hours)
conrm duration set
Setting hours of delay to
start (in the example S4=
4 hours)
conrm delay set
In this example, if at the
time of programming it is
4 pm, the function - lasting
3 hours - will start at 8 pm
(i.e., 4 hours later), then
at 8 am, then again at 8
pm and so on, with a non-
variable frequency of 12
hours between one ltering
and the other.
Filtering is used to lter and sanitise water by sequentially
activating water pumps, blowers (if present) and recirculation
pumps. When active, the display shows the message "FLT"
alternating with the water temperature.
If a user starts a function (e.g., the whirlpool) while the ltering
function is also active, the ltering function is temporarily
interrupted and starts again 15 minutes after the function
started by the user is turned off.
There are 2 lterings per day having a default duration of 2
hours each (duration that can be set by the user), 12 hours
apart from each other (non-variable value).
Change the factory settings (two lterings per day lasting two
hours each) only if necessary.
PROGRAMMING
• Press the "hidden" key ( located below the display, even
if it is not visible it is active) and then, within three seconds,
the
+
key.
• The display shows the word "dx", where "x" indicates the
duration in hours of ltering (e.g., d2 = 2 hours of ltering
- default value) .
• Set the desired duration with
+
or
-
(valid values from
0 (no ltering) to 12h (continuous ltering) ;
• Press the key to start the entered value.
• After the key is pressed the new ltering time is stored and
the next parameter is set, i.e., after how many hours from
the programming the function must start.
• The display shows the message “Sx”, where “x” indicates
the hours of delay (e.g., S4= the function will start after 4
hours from the hour in which the programming is being
done).
• Set the value desire using the
+
or
-
keys (valid range:
from 0 (ltering starts immediately after programming) to 12h
(ltering will start after 12 hours) .
• Press the key to start the entered value.
Once programmed, the function starts after the set delay and
will be repeated every 12 hours for the duration set.