treesse Shadow - Positioning the Minipool

7
EN
Shadow minipool Transport and position
2
POSITIONING
TEMPORARY POSITIONING
The installation of the minipool should be done
immediately upon receipt.
In any case, once unpacked, if it is necessary to
temporarily place it on a surface awaiting the installation,
it will be necessary to place level concrete slabs having
a minimum thickness of 5 cm under the entire bottom
of the minipool.
Since the temporary base may shift, it is recommended
to leave the minipool in that position for the shortest
possible time.
POSITIONING IN THE PLANNED LOCATION
In case of installation above ground (freestanding),
place the minipool in the installation environment (out-
doororindoor)andverifyitsperfectatness,essential
for proper operation.
For a recessed installation, lower the minipool into the
prepared space.
If it was not possible to provide a technical
inspection port on all sides of the minipool, a
removable inspection hatch positioned on the
side where the minipool components are situated, is
recommended.
Do not leave the empty minipool in DIRECT
SUNLIGHT. The surface temperature could rise
above 80°C resulting in serious damage, including
cavitation and the deformation of the surface and com-
ponents. Damage caused by direct exposure to sunlight
is not covered by the warranty.
In such conditions place a cover(xedormobile)to
protect the minipool.
80°C
176°F