Trek SUPERCALIBER SL - Safety and General Information; Properly Tighten Hardware; Reapply Threadlocker; Manual Scope

2024 Supercaliber
2
Safety
WARNING
Properly tighten hardware
Always tighten hardware to the specied torque.
Over-tightening hardware could deform or break the
hardware or components. Under-tightening hardware
could cause hardware or components to become loose.
Either situation could damage the bicycle and result in
injury to the rider.
WARNING
Reapply threadlocker
All reused-fasteners with pre-applied threadlocker must
be cleaned with isopropyl alcohol and have new thread-
locker applied before re-assembly. If threadlocker is not
applied, the fasteners may loosen which could damage
the bicycle and result in injury to the rider.
Scope
This manual contains parts diagrams, specications (such
as grease and torque values), instructions, and helpful
tips. It does not contain instructions for all components
(such as brake calipers). Refer to the original manufactur-
er for more information.
Legend
Apply grease
Do not apply grease
Apply threadlocker
Nm
Torque

Zip tie
Additional resources
• Trek’s YouTube channel: youtube.com/trekbikes
• Trek Owner’s Manual: trekbikes.com/manuals
• RockShox SIDLUXE IsoSrut Service Manual found on
SRAM’s dealer portal.