Trellix NS3200 - Page 12

f Set the IP address of the Manager server. Type set manager ip <A.B.C.D> at the prompt.
Example: set manager ip 192.2.2.2
g Set the IP address and subnet mask of the Sensor. Type set sensor ip <A.B.C.D> <E.F.G.H> at the
prompt.
Example: set sensor ip 192.3.3.3 255.255.255.0
Note
Specify an IP address using four octets separated by periods: X.X.X.X, where X is a number between 0
and 255, followed by a subnet mask in the same format.
h If prompted, reboot the Sensor. Type reboot
Note
The Sensor can take up to ve minutes to complete its reboot.
i Ping the Manager from the Sensor to determine if your conguration settings to this point have
successfully established the Sensor on the network. At the prompt, type the following command:
ping <manager IP address>
If the ping is successful, continue with the following steps. If not, type show to verify your conguration
settings and check that the information is correct.
j Set the shared secret key value for the Sensor. At the prompt, type the following command:
set sensor sharedsecretkey
The Sensor then prompts you to enter and then conrm the shared secret key value.
Note
This value is used to establish a trust relationship between the Sensor and the Manager. The secret key
value can be between 8 and 25 characters of any ASCII text. The shared key value is case-sensitive.
Make sure that the value matches the shared secret key value you provided in the Manager interface
while adding the Sensor.
k Type show to verify the conguration information. Check that all information is correct.
l Type exit to exit the session.
12