e Click Devices | <Admin Domain> | Devices | Setup | Physical Ports.
f To view port settings, select the port on the Sensor that you cabled. Ensure that your port settings match
the cabling. For example, if port 1 is cabled for inline mode, the mode of operation in the port setting
should be inline mode.
Note
For more information on port settings, see the chapter Conguring the monitoring and response ports of
a Sensor in Trellix Intrusion Prevention System Product Guide.
10 You're up and running!
Your Sensor is actively monitoring connected segments and communicating with the Manager for
administration and management operations.
a
For detailed usage instructions, see Trellix Intrusion Prevention System Product Guide, or click
in the
upper-right corner of each window in the Manager.
b Go to Analysis | <Admin Domain> | Attack Log to view alert statistics as attacks are detected. A
summary of alerts is displayed in the Attack Severity Summary monitor of the Manager Dashboard
page.
c Having problems? Check Trellix Intrusion Prevention System Product Guide for troubleshooting information.
d Most deployment problems stem from conguration mismatches between the Sensor and the network
devices to which it is connected. Check your duplex and auto-negotiation settings on both devices to
ensure they are synchronized.
If you need to contact Technical Support, go to https://www.trellix.com/en-us/support.html.
15
To Next Page
Loading...