Trellix NS3200 - 8 Configure Sensor information

Retype the password in Conrm Shared Secret.
Note
The Sensor name and shared secret key that you enter in the Manager must be identical to the
shared secret that you will enter later during physical installation or initialization of the Sensor
(using CLI interface) as stated in the Congure Sensor information section. If not, the Sensor will not
be able to register itself with the Manager.
3) Device Type — Species the type of device to be added. Select IPS Sensor.
4) Deployment Mode — Select Direct or Indirect.
Note
Selecting Direct enables online Sensor update. Direct is the default mode.
5) Contact Information — (Optional) Type the contact information.
6) Location — (Optional) Type the location.
7) Comment — (Optional) Type the comment.
e Click Save.
The added Sensor is displayed on the Sensors tab of Device Manager page.
8 Congure Sensor information
Congure the Sensor with the network information, a name, and the shared secret key that the Sensor uses to
establish secure communication with the Manager. Use the name and key values you set in Add the Sensor to
the Manager section.
Tip
You must have physical access to the Sensor when you congure a Sensor for the rst time.
10