-10-
function of the control unit.
• For category M vacuum cleaners that were in
contaminated environments, the exterior as well as
all machine parts should be cleaned or treated with
sealants.
• When performing maintenance and repair work, all
contaminated components that cannot be cleaned
satisfactory must be disposed of.
• Such components must be disposed of in
impermeable plastic bags conforming to the valid
national regulations for the disposal of such waste.
• For user servicing, the machine shall be dismantled,
cleaned and service, as far as is reasonably
practicable, without causing risk to the maintenance
staff and others. Suitable precautions include
decontamination before dismantling, provision for
local filtered exhaust ventilation where the machine
is dismantled, cleaning of the maintenance area and
suitable personal protect.
• The method by which covers of non-dust proof
compartments should be removed for cleaning.
• The outside of the machine is decontaminated by
vacuum cleaning methods and wiped clean or treated
with sealant before being taken out of a hazardous
area. All the machine part shall be regarded as
contaminated when removed from the hazardous area
and appropriate action taken to prevent dust dispersal
• Operators should observe any safety regulation
appropriate to be the material being handled
For maintenance on behalf of the user, the vacuum
cleaner must be disassembled, cleaned and maintained
as far as feasible, without causing a risk for the
maintenance personnel or other persons. Prior to
disassembly, the vacuum cleaner should be cleaned in
order to prevent any risks. The room/enclosure in which
the vacuum cleaner is disassembled should be well
ventilated. Wear personal protective equipment during
maintenance. After maintenance of the appliance, the
maintenance area should be cleaned.
Cleaning
WARNING:
Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the appliance.
These chemicals may weaken the materials used
in these parts. Never let any liquid get inside the
machine; never immerse any part of the appliance
into a liquid.
• Vacuum the outside of the dust extractor. Clean the
exterior part of the machine with a dry cloth.
• After use dispose of the cloth in an appropriate
container.
Cartridge Filter - (Fig 7.)
Cartridge filter should periodically be washed only
externally under running water to avoid damage to the
filter surface.
It is recommended however that this filter be replaced
every six months, or in relation to the frequency of use
and to the type of dirt.
WARNING:
Once the filter has been cleaned, check whether it
is suitable for further use. If it has been damaged
or broken, replace it with an original filter.
Lubrication
• Your appliance requires no additional lubrication.
Storage
• Empty the container. Clean the vacuum inside and
outside, refer to the Cleaning section.
• Clean or replace filters, refer to the Filters section.
• To prevent back injuries, remove a full disposal
collection bag, or drain vacuumed up fluid before
transporting the vacuum cleaner.
• Wind the cable around the carrying handle and wrap
suction hose around container.
• Carry the vacuum cleaner only by the carrying handle.
• Store appliance and accessories in a safe place.
• Place the unit and accessories in a dry room and
secure it from unauthorized use. Store out of reach of
children.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
as waste.
Accessories and packaging should be sorted for
environmental-friendly recycling.
Separate collection. This product must not be disposed
of with normal household waste.
Household User
Local regulations may provide for separate collection
of electrical products from the household, at municipal
waste sites or by retailer when you purchase a new
product. Please call Trend Customer Services for advice
as to how to dispose of unwanted Trend electrical
products in an environmentally safe way or visit www.
trend-uk.com
Business Users
Please call Trend Customer Services for disposal of
unwanted Trend electrical products.
EN - T32
To Next Page
Loading...
