-5-
example in hotels, schools, factories, shops and offices.
The appliance is intended for use as a dry vacuum
cleaner only.
DO NOT let children come into contact with this
appliance. Supervision is required when inexperienced
operators use this appliance.
WARNING: Ensure all filters are fitted.
WARNING: Operators shall be adequately
instructed on the use of these machines.
WARNING: Do not allow the supply cord to
come into contact with the rotating brushes.
WARNING: This machine is for dry use only.
WARNING: This machine is not suitable for
picking up hazardous dust.
WARNING: The machine has to be
disconnected from its power source during
cleaning or maintenance and when replacing parts
or converting the machine to another function for
mains operated machines, by removing the plug
from the socket-outlet
WARNING: Children should be supervised to
ensure that they do not play with the appliance
CAUTION: This machine is for indoor use only.
CAUTION: This machine shall be stored
indoors only.
CAUTION: Do not overload suction.
CAUTION: Clean filters daily.
CAUTION: Do not over fill bag.
DO NOT use vacuum cleaner for combustible dust.
DO NOT use vacuum cleaner in explosive atmospheres.
This product is not intended for use by persons
(including children) suffering from diminished physical,
sensory or mental abilities; lack of experience,
knowledge or skills. Children should never be left alone
with this product.
Electrical Safety
Power Supply
WARNING:
Before any maintenance work, isolate mains plug
from power source
The electric motor has been designed for one voltage
only. Always check that the power supply corresponds
to the voltage on the rating plate. Machines marked for
230 volt can also be operated from a 220 volt supply.
The vacuum cleaner is supplied from the factory with
mains supply power cord/cable, which has an earthed
plug. It must only be connected to an approved earthed
socket.
Mains Plug Replacement (UK &
Ireland only)
Always check the condition of the cable and plug before
starting with your work. Should your mains plug need
replacing and you are competent to do this, proceed
as instructed below. If you are in doubt, contact an
authorised Trend repair agent or a qualified electrician.
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug with
bared copper conductors is dangerous if engaged in a
live socket outlet.
• Only fit 13 Amperes BS 1363A approved plugs fitted
with a 13 Amp A.S.T.A approved BS 1362 fuse (1).
• The cable wire colours, or a letter, will be marked at the
connection points of most good quality plugs. Attach
the wires to their respective points in the plug (see
below). Brown is for Live (L) (2) and Blue is for Neutral
(N) (3).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (4) is holding the outer
sheath of the cable firmly and that the two leads are
correctly fixed at the terminal screws.
For 115V units with a power rating exceeding 1500W
we recommend to use a plug to BS4343 standard.
WARNING:
Never connect to a light socket. Never connect
the live (L) or neutral (N) wires to the earth pin
marked E or .
Using an Extension Cable
• If an extension cable is required, use an approved triple
core extension cable suitable for the power input of
this tool (see technical data). The minimal conductor
size is 1.5mm2, the maximum length is 30m.
EN - T32
To Next Page
Loading...
