-9-
container deflector flange. Close the bag by flipping the
tab over.
Dispose of the filter in a suitable container according to
the applicable laws.
It is good practice however, to change the bag regularly
to guarantee optimal cooling of the motor.
If the vacuum cleaner is used without the paper dust
bag, it is recommended that the dust container be
emptied and cleaned after each use.
The collection bag must be
replaced when the extraction velocity
monitor goes to red and stays on red.
Mounting the Hose, Nozzles and
Tubes - (Fig.5,5a)
• Connect the hose to the container by pushing the hose
with bayonet fitting into the container hose inlet ensure
bayonet tabs are vertical and turn clockwise to lock.
To remove hose, turn hose with bayonet fitting anti-
clockwise to remove from the inlet.
• The spouts are a push fit on the extension tubes. To
remove the spouts, turn the parts in the opposite
direction and pull apart.
• For carpets use the universal spout.
• For floors, clip the brush spout insert into the universal
spout.
Fitting/Removing Cartridge
Filter - (Fig.6)
• The filter cartridge has to be completely pushed in
and is secured by turning the butterfly nut clockwise.
Check that it fits correctly.
In order to remove the cartridge filter turn the butterfly
nut anti-clockwise and withdraw the cartridge filter.
Ensure the seal around the retaining screw is in place.
Before using the appliance
always check that all the filters
provided are in the correct position.
OPERATION
Starting Operation
Observe correct mains voltage! The voltage of the power
source must agree with the voltage specified on the
nameplate of the vacuum cleaner. Equipment marked
with 230V can also be operated with 220V. Please refer
to the HSE guidelines concerning the handling of
materials that are hazardous to one’s health.
• The machine must be always kept on horizontal
bases, in a safe and stable way.
• Insert the suitable filters for the proper use.
• Never use the appliance without the filters.
• Use the most suitable accessories for the requested
usage.
The vacuum cleaner may generally not be used in
rooms where the danger of an explosion exists. To
save energy, only switch the vacuum cleaner on when
using it.
Dry Vacuuming
Never use the appliance without the polyurethane foam
filter, cartridge filter or the collection bag.
• Fit the cartridge and lock in position using the
butterfly screw.
• To switch the vacuum cleaner on, press button down.
To switch the vacuum cleaner off, press button down
to release. If extraction velocity monitor is red, press
and hold filter shaker button for 3 seconds. (device/
extraction must be on) filter will continue shaker
function for a further 5 seconds after release. If the
monitor turns red only as and when you connect to a
power tool, ensure that the extraction spouts of the
tool and hose are not blocked. If clear, it is OK to use.
Check the flow periodically by removing the extraction
hose.
If red monitor continues the dust bag may be full, and
will need to be replaced. See Filter
NOTE: An adequate ventilation rate (M) must
be provided for when the outgoing air is circulated.
Observe the respective national regulations.
MAINTENANCE AND SERVICE
Please use only Trend original spare parts accessories.
• Before any work on the vacuum cleaner itself, isolate
from the power supply.
• For safe use and to ensure the appliance works
properly, always keep the vacuum cleaner and
ventilation slots clean.
• Wear a dust protection mask when maintaining and
cleaning the vacuum cleaner.
• If the replacement of the power cable is necessary,
this has to be done by Trend or a Trend Service
Agent in order to avoid a safety hazard.
• A dust-technical inspection is to be carried out
at least once every year by the manufacturer or
an instructed person, e.g. for damage of the filter,
tightness against leakage of the vacuum cleaner and
EN - T32
To Next Page
Loading...
