TREND TB/TC/S User Manual

TB/TC/S Strap-on Temperature Sensor Installation Instructions TG201240 Issue 2, 18-Dec-2015. 1
Installation Instructions
TB/TC/S
Strap-on Temperature Sensor
Important: Retain these instructions
These instructions shall be used by trained service
personnel only.
If the equipment is used in a manner not
specied by these instructions, the protection provided by the
equipment may be impaired.
https://partners.trendcontrols.com
1
Dimensions
2
Requirements
2 INSTALLATION
1 BOX CONTENTS
CONTENTS
1 Box Contents .................................................................1
2 Installation .....................................................................1
3 Disposal .........................................................................4
TB/TC/S
Installation
instructions
printed on box
Ø 4.5 mm
Ø 15 to 140 mm
42.2 mm
22.2 mm
20 mm
60 mm
60 mm
67 mm
Ø 5.5 to 9 mm
11 mm
(0.18”)
(0.79”)
(0.87”)
(1.66”)
(0.59 to 5.51”)
(2.36”)
(2.36”)
(2.64”)
(0.43”)
(0.22 to 0.35”)
Protection :IP42 as per IEC 529
HO
2
5 %RH 95 %RH
-30 °C
(-22 °F)
+100 °C
(+212 °F)
to
-5 °C
(+23 °F)
+50 °C
(+122 °F)
to
100 mm or
greater
lagging
d
mixing
>=10d

TREND TB/TC/S Specifications

General

Supply Voltage	24 VAC/DC
Control Method	On/Off
Display	LED
Operating Temperature	0 to 50°C
Storage Temperature	-20 to 60°C

Summary

Box Contents

Installation

Dimensions

Details the physical dimensions and mounting compatibility of the sensor.

Requirements

Specifies the operating environmental requirements and protection ratings for the sensor.

Remove Cover

Instructions for safely removing the sensor cover before proceeding with installation.

Mount on Pipe

Details the procedure for mounting the sensor onto a pipe using the provided strap.

Insert Cable

Guides on how to insert the signal cable, either through a grommet or a cable entry gland.

Connect to Controller

Explains how to connect the sensor's signal wires to the controller, including cable recommendations.

Replace Cover

Instructions for refitting the sensor cover after wiring connections have been made.

Configure IQ

Details the process of configuring the sensor settings within the IQ system.

Set up IQ Sensor Type

Guides on setting the sensor type and scaling parameters for accurate temperature readings.

Test Operation

Describes the final step of testing the sensor's operation after installation and configuration.

Disposal

WEEE Directive

Information regarding the disposal of the product and packaging according to WEEE regulations.