Page 15
Configuration Screens
The following configuration screens are available.
TCP/IP
Figure 11: TCP/IP Screen
IP Address
DHCP Client Select this if your LAN has a DHCP Server.
The Print Server will then automatically obtain an IP address
from the DHCP Server.
Fixed IP
Address
Select this to assign a fixed IP address to the Print Server. If
selected, you must enter the Device IP Address, Subnet Mask,
and Gateway.
Device IP
Address
IP Address assigned to the Print Server.
Enter an unused IP address from the address range used on
your LAN.
Subnet Mask
Use the same values as PCs on your LAN (or on the same LAN
segment, if you have a Router).
Gateway
Address
Use the same values as PCs on your LAN (or on the same LAN
segment, if you have a Router).
Connection
Delay before
reconnection
attempt
Sets how long the Print Server should wait before retrying a
TCP/IP connection which is lost. Allowable values are from 0
to 255 seconds, with 2 as the default.
Number of
reconnection
attempts
Set how many attempts at reconnection will be made. After
that, the TCP/IP session will be terminated.
Allowable values are from 0 to 255, with 254 as the default.
To Next Page
Loading...
Need help?
General
