ENGLISHFRANÇAISDEUTSCHESPAÑOL
ÐÓÑÑÊÈÉ
2. Hardware Installation
2
Note: Locate an optimum location for the Access Point. The best place for the Access
Point is usually at the center of your wireless network. Please connect the computer
configuring the TEW-653AP to the same switch/hub.
1. Run a RJ-45 cable and the power adapter
through the cable clip on the TEW-653AP.
3. Connect the Power Adapter to the Access Point
and then to a power outlet.
2. Connect the RJ-45 cable from the Switch/Hub
to the LAN port on the Access Point.
4. Verify that the wireless, LAN and power LEDs
are on.
To Next Page
Loading...
Need help?
General
