5
15. Select the desired WPA mode, enter
characters for your Pre-Shared key and then
click Next. For WPA-PSK or WPA2-PSK, the
Pre-Shared Key must be between 8 and 63
ASCII or 64 HEX characters. Make sure to
copy down the Pre-Shared Key.
16. Click Save (optional). This saves your
configuration settings in a file, which can be
reloaded when needed.
18. Click Configure to apply the settings.
17. Give the file a name, then click Save.
Note:
1. To protect your network from any unauthorized access it is recommended to enable wireless
encryption.
2. The fexample below is for WPA2-PSK security. If you select WPA-PSK or WPA2-PSK, make
sure your wireless adapters support WPA or WPA2. If your wireless adapters do not support
WPA or WPA2, then select WEP.
To Next Page
Loading...
Need help?
General
