ENGLISHFRANÇAISDEUTSCH
ESPAÑOLРORTUGUÊS
1
1. Before You Start
Note:
It is recommended to use network cables without additional caps, molded caps, or boots with
the access points for cable fitment inside the enclosure.
Note:
The TEW-740APBO does not support IEEE 802.3at/af PoE standards. You must use the
proprietary Power over Ethernet injector that is supplied with the TEW-740APBO. The RJ-45
Ethernet cable between the passive PoE injector and access point can have a maximum length
of up to 60 m (197 ft.).
Package Contents
Ÿ 2 x TEW-740APBO
Ÿ CD-ROM (User's Guide)
Ÿ Quick Installation Guide
Ÿ Proprietary PoE injectors
Ÿ Power adapters (12 V DC, 1A)
Ÿ Mounting Hardware
Ÿ Grounding wires
Minimum Requirements
Ÿ Computer with a network port and web browser
Ÿ A network switch or router with an available network LAN port
Ÿ Phillips screwdriver (Ground wire installation)
Ÿ 4 x RJ-45 network cables
To Next Page
Loading...
Need help?
General
