© Copyright 2014 TRENDnet. All Rights Reserved.
12
TRENDnet User’s Guide
TEW-815DAP
• WPA Encryption: Select WPA AES or TKIP encryption you would like to use.
• WPA passphrase: Enter the security password. This is the password or key that is
used to connect your computer to this access point wirelessly.
• Network Key Rotation: Enter the key rotation interval to use for WPA encryption.
Selecting WPA/ WPA2/WPA2 Mixed (WPA2 recommended):
The following section outlines options when selecting WPA (EAP or RADIUS). This
security type is also known as EAP (Extensible Authentication Protocol) or Remote
Authentication Dial-In User Service or RADIUS.
Note: This security type requires an external RADIUS server, Pre-Shared Key only requires
you to create a passphrase.
• WPA Encryption: Select WPA AES or TKIP encryption you would like to use.
• Network Key Rotation: Enter the key rotation interval to use for WPA encryption.
• RADIUS Server Address: Enter the IP address of the RADIUS server. (e.g.
192.168.10.250)
• RADIUS Port: Enter the port your RADIUS server is configured to use for RADIUS
authentication.
Note: It is recommended to use port 1812 which is typical default RADIUS port.
• RADIUS Key: Enter the shared secret used to authorize your access point with your
RADIUS server.
Connect wireless devices to your access point
A variety of wireless network devices can connect to your wireless network such as:
Gaming Consoles
• Internet enabled TVs
• Network media players
• Smart Phones
• Wireless Laptop computers
• Wireless IP cameras
Each device may have its own software utility for searching and connecting to available
wireless networks, therefore, you must refer to the User’s Manual/Guide of your
wireless client device to determine how to search and connect to this access point’s
wireless network.
See the “
Appendix” on page 49 for general information on connecting to a wireless
network.
To Next Page
Loading...
Need help?
General
