TRENDnet TEW-PCI User Manual

PCI Wireless Network Adapter User’s Manual
19
4. The following screen will ask you to restart your computer to finish the hardware
setting up. Click Yes to restart your computer to make the hardware setting up
available.
P.S. : In most cases, Windows will automatically copy all of the files needed for
networking. If Windows ask you for the files and prompt you to input the path to the
files. Follow the instructions on your screen, and then click OK to continue.
Driver installation for Windows NT4.0
This installation procedure assumes that you have installed the network component on
your computer.
To check whether the network component has been installed, double click the
Network icon in the Control Panel. If it has not been installed, refer to the Windows
NT 4.0 installation guide for instructions on installing the component.
Follow the steps below to install the driver.
1. Insert the PCI Wireless Network Adapter to PCI slot of desktop PC. ( Refer to
Page8 – Hardware installation. )
2. Log in to NT 4.0 as Administrator.
3. Double click the Network icon in the Control Panel, and select the Adapters tab
as shown in the following screen. Then click Add to add a new adapter to
continue.

TRENDnet TEW-PCI Specifications

Wireless Specifications

standards	IEEE 802.11b
frequency	2.4 to 2.4835GHz
data rate	up to 11Mbps

Operating Environment

operating temperature	0° ~ 55° C
storage temperature	-25° ~ 70° C
humidity	10% to 90% (non-condensing)

Operating Ranges

indoor range at 11Mbps	up to 50M
indoor range at 5.5Mbps	up to 80M
outdoor range at 11Mbps	up to 150M

Weight and Dimensions

dimensions	135 x 22 x 121 mm (without the antenna)
antenna length	108 mm