TRENDnet TI-RG262i User Manual

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
Managed Industrial L2 Switch
141
Manual Registration
Management > Device Management > Manual Registration
If devices do not support LLDP and ONVIF, user has to enter the details of it by manually
under manual registration. The function supports three type, IP-Cam, PLC and Switch.
For devices which do not support ONVIF or LLDP, User can input the device’s MAC
address and then the Switch will discover the device and display it on the
Topology/Netlite Map in the Topology map web GUI page.
Node
Command
Description
enable
show netlite-device
This command displays the netlite-device whose
MAC are manually entered
configure
netlite-device type
ipcam mac
This command adds a MAC address of an IP-cam to
display on netlite.
configure
netlite-device type
plc mac
This command adds a MAC address of a PLC to
display on netlite.
configure
netlite-device type
switch mac
This command binds the MAC address to a
particular port
configure
no netlite-device
mac
This command removes device from netlite..
Web Configuration
Management > Device Management > Manual Registration
Parameter
Description
Type
Select the type of device to display on Topology/Netlite map. IP-
Cam, PLC, or Switch.
MAC Address
Enter the MAC address of the device to add to the topology map.
(00:11:22:aa:bb:cc)

TRENDnet TI-RG262i Specifications

General

Brand	TRENDnet
Model	TI-RG262i
Category	Switch
Language	English