TRENDnet TI-RG262i User Manual

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
Managed Industrial L2 Switch
140
ONVIF
Management > Device Management > ONVIF
ONVIF is an open industry forum that provides and promotes standardized interfaces for
effective interoperability of IP-based physical security products.
The Switch use ONVIF to discovery if there is ONVIF device connected to the Switch.
The page show the detail information about ONVIF settings and ONVIF devices connected
to the Switch. The Switch displays ONVIF devices up to total port count, IEN-8428PL shows
upto 10 ONVIF devices connected to it. If one or more ONVIF devices are connected to
the same port it displays the last ONVIF device gets connect to it.
Important
Node
Command
Description
enable
show onvif
This command displays the onvif configurations.
enable
show onvif
neighbor
This command displays all of the ports’ neighbor
information.
configure
onvif enable
This command enables onvif function on the
Switch.
configure
onvif tx-interval
This command configures the interval to transmit
the onvif packets.
configure
onvif binding-ports
This command binds the MAC address to a
particular port
configure
no onvif tx-interval
This command configures the onvif packets
transmit interval to the default value
configure
no onvif binding-
ports
This command binds the MAC address to a
particular port
Web Configuration
Management > Device Management > ONVIF
Parameter
Description
State
Globally enables / disables the ONVIF on the Switch.
Tx Interval
Sets the interval time in seconds when to send transmit ONVIF
packets.

TRENDnet TI-RG262i Specifications

General

Brand	TRENDnet
Model	TI-RG262i
Category	Switch
Language	English