TRENDnet TI-RG262i - Monitor; Alarm; Port Statistics

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
Managed Industrial L2 Switch
122
Monitor
Alarm
The feature displays if there are any abnormal situation need process immediately.
Notice: The Alarm DIP Switch allow users to configure if send alarm message when the
corresponding event occurs.
For Example:
P1: ON, The Switch will send alarm message when port 1 is link down.
PWR: ON, The Switch will send alarm message when the main power supply disconnect.
RPS: ON, The Switch will send alarm message when the redundant power supply
disconnect.
CLI Configuration
Node
Command
Description
enable
show alarm-info
This command displays alarm information.
Web Configuration
Monitor > Alarm
Parameter
Description
Alarm Information
Alarm Status
This field indicates if there is any alarm events.
Alarm Reason(s)
This field displays all of the detail alarm events.
Alarm DIP Switch Settings
DIP Switch
The field displays the DIP Switch name.
Status
The field indicates the DIP Switch current status.
Port Statistics
This feature helps users to monitor the ports’ statistics, to display the link up ports’ traffic
utilization only.
CLI Configuration
Node
Command
Description
enable
show port-statistics
This command displays the link up ports’
statistics.
Example:
[DEVICE_NAME]#show port-statistics
Packets Bytes Errors Drops
Port Rx Tx Rx Tx Rx Tx Rx Tx
---- -------- -------- -------- -------- -------- -------- -------- --------
3 1154 2 108519 1188 0 0 0 0